Kit cars in the USA

   
 "Dedicated to American Kit Cars" Information about Kitcar USA.com Contact Kitcar USA.com         Home of American kit cars - Kitcar USA.com Kitcar articles All the latest kit car news Kit car discussion for the enthusiast

Search

Manufacturers
Kit Cars
Car Spec Sheets
Picture Gallery
Kit Car Clubs
Build cost estimator
Kit Cars for sale
Madabout-Kitcars
Classic-Kitcars

 

CATEGORIES (articles) > Transmission > Components > Hotchkiss drive for rear wheel drive cars

Hotchkiss drive for rear wheel drive cars


The Hotchkiss drive is a system of power transmission. It was the dominant form of power transmission for front-engine, rear-drive cars in the 20th century. The name comes from the French automobile firm of Hotchkiss, and dates to the earliest use of the system, although it is clear that other makers (such as Peerless) used similar systems before Hotchkiss.

During the early part of the 20th century the two major competing systems of power transmission were the shaft-drive and chain-drive configurations. The Hotchkiss drive is a shaft-drive system (another type of direct-drive transmission system is the torque tube, which was also popular until the 1950s).

All shaft-drive systems consist of a driveshaft (also called a "propeller shaft" or Cardan shaft) extending from the transmission in front to the differential in the rear. The differentiating characteristic of the Hotchkiss drive is the fact that it uses universal joints at both ends of the driveshaft, which is not enclosed. The use of two universal joints, properly phased and with parallel alignment of the drive and driven shafts, allows the use of simple cross-type universals. (In a torque tube arrangement only a single universal is used at the end of the transmission tailshaft and this should be a constant velocity joint.) In the Hotchkiss drive, splines eliminate thrust transmitted back up the driveshaft from the wheels, allowing simple rear-axle positioning using parallel leaf springs. (In the torque tube type this thrust is taken by the torque tube to the transmission and thence to the transmission and motor mounts to the frame. While the torque tube type requires additional locating elements, such as a Panhard rod, this allows the use of coil springs.)

Some Hotchkiss driveshafts are made in two pieces with another universal joint in the center for greater flexibility, typically in trucks and specialty vehicles built on truck frames. Some installations use rubber mounts to isolate noise and vibration.

This has been the main form of power transmission for most cars from the 1920s through the 1970s, and remains common in pick-up trucks and sport utility vehicles, although it has become relatively rare in passenger cars. One notable exception was Buick, which used a torque tube for some years through the 1954 model year. Another notable exception was Peugeot.




Related Articles

CATEGORIES (articles) > Transmission > Components > Hotchkiss drive for rear wheel drive cars

 
Search for keyword     



This content from Wikipedia is licensed under the GNU Free Documentation License.


copyright © KitcarUSA.com 2024
terms and conditions | privacy policy